Given that many people have asked me to show here, more in promenor how do I do the padding of interior panels and seats, I want to say that this is a relatively simple and easy work to do, however, there are some points It is necessary to take into consideration, first point is to make the molds in paperboard, with the exact dimensions and drilling of the number of the materials are, 1mm plywood sponge 2mm, the skin is natural and thick, Thin, 1mm, the lines to crease the diamonds should be the hardest, polyester, to make the French knots is used crochet, the glue used is the fabric, gutermann brand, it is important to note that the skin only Is glued behind, and the drilling of the plywood, it is necessary to take into account that the thinner line 4 times through the hole and the crochet line to make the French knot 3 times, so the width of the hole must take into account these If the needle gets too tight, the knot will move to the other side, I use a 1.25mm drill bit.
I hope with this clarification to have answered, to the doubts and questions that have been put to me about this construction of the padding, the seats are made in the same principles also.
Materials used in the construction of the panels.
First the carton blank from which the panel and upholstery are made.
The sponge is cut to the lozenges, to give the deep relief effect.
The panel is finished.
The back of the panel, to see how the stitching is performed
Some details of the interior of the carriage under test
Details of the almost complete set of the front compartment of the carriage.
The wheels have also been painted, as well as the cubes and strips painted on the rim
Here an interior view taken from the front door on the left.
Nenhum comentário:
Postar um comentário