Construction of seats and roof rails

Construction of roof rails and seats, this is a work that requires some practice with regard to welding with 2 mm galvanized wire, from which this work is performed, so that the lateral curvatures are symmetrical, it is necessary make wooden moldings to the right and left side, as well as the slope of the backrest that the seats have, about 5 degrees back and 3 for each side, the wire should be very well sanded and heated with torch in the bending zones , so that it becomes softer and facilitates bending, plus some photos of the execution of this work.

This little video shows how the lights turn on and off.

as you can see the wood of the molds is of oak for greater resistance to the folding of the wire that is 2 mm of thickness and is very hard

the finished driver's seat.

Test to make the rear seat rails.